Emission measurement devices
AT605 4048 BlueNet OPAC KIT
Functions
- This setup is used for replacement of cable interconnection between an opacimeter and a PC.
- This replacement does not need any other steps but setting “Wireless version” in the AT605 “Configuration“.
- The modules are equipped with two indication LEDs:
- Red for on/off indicati
- Blue for indication that the interconnection between modules is active
Technical parameters
- Modules of Power Class 1 are used
- If there is direct visibility between the modules, the maximum range of the interconnection is 100 m
- The PC module is supplied with power form the USB connector with the maximum current consumption of 250 mA
- The Opacimeter module is supplied with power form the Opacimeter connector with a D.C. voltage of 12 V and the maximum current consumption of 250 mA
Set
AT605 4048 BlueNet OPACIMETER KIT
AT605 4048 - AT605 4048 BlueNet OPACIMETER KIT / PWR-RS232
- This setup is used for replacement of cable interconnection between an opacimeter and a PC.
AT605 4040 - BlueNet adapter OPAC/PWR
- bluetooth(BlueNet) module with power supply for Opacimeter
AT130 4006 - BlueNet adapter PC-RS232
- Bluetooth(BlueNet) module for PC
Photogallery
AT605 4044 WLC OPAC KIT (set)
Connection
AT130 4006 – BlueNet adapter PC-RS232
- The PC module (1) is connected to a PC via two connectors.
- USB (1a) only supplies the module with power.
- RS232 (1b) communicates with the PC via an RS232 interface
Photogallery
AT1310 4001 – BT adapter PC-RS232
Connection
AT605 4040 – BlueNet adapter OPAC/PWR
- The Opacimeter modules (2) is connected to the AT605 opacimeter (smoke-opacity meter) with two bolts (commonly used for the stand fixation).
- Both the communication (2b) and power-supply (2a) connectors are set up following the Figure shown below.
- The module further contains the wall-socket power-supply cable (2c) and power switch (2d).
Photogallery
AT1310 4001 – BT adapter PC-RS232
Last page update: November 8, 2018